pmdg 777 problems yoke disengaging autopilot

My lever layout is as follows from left to right 1. Not used (Beacon light turns on automatically), 5. Here is my switch assignment for those switches that can be assigned (from left to right) ġ. Master Caution and Master Warning covered too many functions to make those work so I did not configure them to work.ĭue to the aircraft's three position switch for the taxi and landing lights, I could not replicate the Bravo's two position switches to mimic the three position switch so I turn them on within the aircraft as needed. I did not set up the LEDs for Engine Fire at this time but I will soon. Of course you can set other LEDs that I may not have set up but these are the ones I considered important to me. Same goes for the hydraulic pressure and voltage.Īnti-Ice will illuminate if any of the ice protection is activated, such as wing or engine protection, etc. If the oil pressure is less than what I determined it should be at the lowest setting (i.e., idle speed), the light will illuminate. The LED lights will come on if the criteria isn't met for that particular function (such as oil pressure psi).

LED configuration for the annunciator panel for my Aerobask Phenom 300. This file will do the following (Read the 'What's New' update details down below this original content). I hope to post that aircraft profile when I am certain it is complete. This is absolutely one of my favorite aircrafts right alongside the Beech Premier 1A that's in my hangar. Make sure to have the latest version of the tool before you use it. The profile was made using Honeycomb Configurator v2.1 and might have issues working in older versions. All the bindings are listed below:ĮNGINE FIRE (when LH/RH ENGINE FIRE buttons are lit)ĪUX FUEL PUMP (when fuel boost pumps are turned on)ĭOOR (only for the L1 door currently, as I didn't find the datarefs for the other doors but it's a WIP)Įverything else in the Bravo (Axis, toggle buttons, flaps, gear lever etc) can be easily set within X-Plane 11 itself and is blank in the configuration for you to customize to your liking. The configuration is for all the lights (Gear, Annunciator except 'Vacuum', Autopilot) and for both knobs (Selector and Increase/Decrease).

I have created a Bravo profile for the DeltaWing Simulations CRJ 700 & CRJ 900.

Pmdg 777 problems yoke disengaging autopilot